Easy audio mixer where does it save projects

The gain control sets the signal level of the input signal. There is a separate row of controls for each set of input jacks, allowing you to control each channelвЂ™s input gain, output level, left-right channel balance, and output to auxiliary equipment. The signal for each piece of connected equipment is controlled in this section. The PHONES jack is used for headphones, and, like the C-R OUT jack above, allows you to monitor the sound. This is another jack used to connect the mixer to an amplifier вЂ“ not for the main speakers, but for monitor speakers used while youвЂ™re mixing. The C-R OUT jacks are used to connect the mixed signal to your monitoring system. You may not be able to hear the main speakers while you are at the mixing board, so practice and experience, as well as a close eye on the Level Meters, are crucial. Too high of a signal will greatly distort the sound, and can even possibly damage the amp or speakers.

This is done using the ST Master Fader (see below). It is important to carefully monitor the output level from the mixing board going into the amplifier. The ST OUT jacks are stereo outputs used to connect your Yamaha mixer to a stereo amplifier used for powering your main speakers. The REC OUT jacks can be used for an external recorder. The 2TR input offers unbalanced RCA plugs for an additional stereo source, which will go into the mix without any control other than signal level. There are additional input and output jacks in this section, used for other sources, monitors and processing equipment. These input areas also offer phone plug inputs, usually unbalanced. This is where you would plug in a CD player, tape deck or other source with RCA type connectors.

These channels can also be used for mono signals.Д¬hannels 7-8 and 9-10 are also stereo, and are meant more for consumer electronics equipment.

Channels 1 and 2 are meant for mono signals, and are ideal for microphones (using the balanced XLR connector) or musical instruments with a monaural signal like an electric guitar (using either the balanced or unbalanced phone plug).Д¬hannels 3-4 and 5-6 are stereo inputs, and can be used for stereo microphones, instruments with stereo output signals (like many synthesizers and keyboards) or any other stereo signals.

Easy audio mixer where does it save projects